References 1. Bulson PS (1997) Explosive loading of engineering structures: a history of research and review of recent developments. E&FN SPON, London, p 236 2. Yandzio E, Gough M (1999) Protection of buildings against explosions. Steel Construction Institute, Ascot, p 110 3. Bangash MYH, Bangash T (2006) Explosion-resistant buildings: design, analysis, and case studies. Springer, New York, p 784 4. Jones N (1989) Structural impact. Cambridge University Press, Cambridge, UK, p 575 5. Teeling-Smith RG, Nurick GN (1991) The deformation and tearing of thin circular plates subjected to impulsive loads. Int J Impact Eng 11:77–91 6. Nurick GN, Shave GC (1996) The deformation and tearing of thin square plates subjected to impulsive loads - an experimental study. Int J Impact Eng 18–1:99–116 7. Olson MD, Nurick GN, Fagnan JR (1993) Deformation and rupture of blast loaded square plates - predictions and experiments. Int J Impact Eng 13–2:279–291 8. Neuberger A, Peles S, Rittel D (2007) Scaling the response of circular plates subjected to large and close-range spherical explosions. Part I: Air-blast loading. Int J Impact Eng 34:859–873 9. Neuberger A, Peles S, Rittel D (2007) Scaling the response of circular plates subjected to large and close-range spherical explosions. Part II: Buried charges. Int J Impact Eng 34:874–882 10. Spranghers K, Vasilakos I, Lecompte D, Sol H, Vantomme J (2012) Full-field deformation measurements of aluminum plates under free air blast loading. Exp Mech 52:1371–1384. doi:10.1007/s11340-012-9593-5 11. Sutton MA, Orteu J-J, Schreier HW (2009) Image correlation of shape, motion and deformation measurements: basic concepts, theory and applications. Springer, New York, p 321 12. Tiwari V, Sutton MA, McNeill SR, Xu S, Deng X, Fourney WL, Bretall D (2009) Application of 3D image correlation for full-field transient plate deformation measurements during blast loading. Int J Impact Eng 36:862–874 13. Kingery CN, Bulmash G (1984) Airblast parameters from TNT spherical air burst and hemispherical surface burst. Report ARBL-TR-02555, U.S. Army Ballistic Research Laboratory, USA 14. U.S. Department of the Army (1986) Fundamentals of protective design for conventional weapons, Department of the Army Technical Manual, USA 15. Randers-Pehrson G, Bannister KA (1997) Airblast loading model for DYNA2D and DYNA3D. Report ARBL-TR-1310, U.S. Army Ballistic Research Laboratory, USA 16. Livermore Software technology Corporation (1999) LS-DYNA user’s manual: nonlinear dynamic analysis of structures (Version 950), USA, p. 1024 17. Christoulis DK, Guetta S, Guipont V, Jeandin M (2011) The influence of the substrate on the deposition of cold-sprayed titanium: an experimental and numerical study. J Therm Spray Technol 20(3):523–533 18. Lecompte D (2007) Elastic and elasto-plastic material parameter identification by inverse modeling of static tests using digital image correlation. Vrije Universiteit Brussel, Belgium, p 269 326 K. Spranghers et al.
RkJQdWJsaXNoZXIy MTMzNzEzMQ==